|
Fits 2010-2015 Camaro With Boston Acoustic Sound System
Mount an aftermarket speaker amp with zero modifications
Mounts in the same spot as the factory amp
Slips into the straps and bolts down like the factory amp
Lightweight and easy to install
Effective mounting area: 7.75" x 10.5"
Amps larger than this will not fit
Covered in matching gray carpet
Can also be used to mount sound processors
Please note that on most cars, right below where the stock amp mounts, the factory seam filler sealant can sometimes be so excessive that it can interfere with installing our mount. Therefore in these cases, the seam filler will need to be trimmed away slightly with a razor to allow our amp mount to install without interference.
Are you thinking about ditching your weak-powered, poor-sounding factory Boston Acoustic Amplifier for a better one? If so, we have a very nice mount that will give you a nice flat surface to screw your new amp into; without putting any holes in your car. This mount is made to fasten to the car just like the factory amp does. The tabs on one side slip ino the mounting straps and the slotted hole on the other end goes over the stud. Simply slide the mount into place and tighten down the nut. You can even mount your new amp to the mount first and install the amp and mount as an assembly. What could be easier than that? The mount comes covered in a charcoal gray carpet that matches the rest of your factory trunkliner carpet. Please note that this spot is quite small. The size of the mounting area is listed above. We will not answer will my amp fit questions. Please check the footprint of your intended amp to ensure it will fit.
|
Email Us:
