Fits: 2016-2017 Camaro Coupe With BOSE Amplifier (Diagonal fins)
Also works on 2015 & Up Colorado/Canyon Pickups with Bose Stereo
Provides 2-channel Stereo Output For Adding Additional Amplfiers ie a Subwoofer Amp.
On Colorado/Canyon, use Green and White wire sets as these are the front door speakers (which contain all the bass)
Easy Plug and Play installation. Access the amp behind the passenger side glovebox. Pull the black plug and install this harness in-line. Getting the black plug out is a bugger but doable.
A very valuable tool if you intend to do any kind of wiring to the trucks audio system like adding a subwoofer. This will save you lots of time and hassle.
Note: New Colorados and Camaros do Not provide 12v switched power switching on aftermarket amplifiers. Therefore no switched power is present on the harness. Also note that Bose systems have digital inputs from the radio to the amp, which cannot be interecepted for adding amplifiers. Therefore our harness borrows the signal 'after' the amp, which is a high power signal--hence no rca jacks.
Therefore, you will need to use an amp with signal sensing high level input capabilities OR a signal processor with signal sensing input to trigger on your amp. Also we have found that only the Front Door channels are strong enough to trigger on an amp.
Note: BOSE equipped stereos may have ANC (Active Noise Cancellation) Which means there are microphones in the vehicle that detect cabin noise and attempt to quiet that noise by playing opposite tones thru the car's speakers. From our tests, if the microphones are not defeated in some manor, they will pick up the bass tones from your newly installed subwoofer and your entire system will play at high erraneous levels (only with the vehicle running). The ANC plug is typically the brown plug on the amp. We are developing a simple ANC microphone delete harness for this exact reason but will be some time until it is released. It is possible to pull the plug completely but there are still some important wires contained on that plug. From our tests, with the ANC plug unplugged we noticed a loss of the rear parking sensors. For now you can either find the mics and unhook them or clip either the pos. or neg. pin for each microphone. If you don't want to clip any wires, it is possible to take the connector apart and pull the mic wires out.
3 channel blunt cut leads approximately 13" long (only 2 active channels for Colorado/Canyon)
Can be extended by user as needed.
Wire Color Function
green wires left rear channel solid is+ blk stripe is-
gray wires not used for Colorado
white wires left front channel solid is+ blk stripe is-
Note: Please be sure your truck has the BOSE Amp, which can be found behind the glove box. The BOSE Amp has Diagonal Fins. See Example Photo under the More Images Tab Above.
If your truck has No amp at all, then we have no harness for those non amp applications at present.